rust-soham/golem-claw/golem-interrupt-resume-agent

Interrupting and Resuming an Agent

Both golem and golem-cli can be used — all commands below work with either binary.

The <AGENT_ID> format depends on the agent's language — refer to the language-specific invocation skills for the exact syntax.

agent interrupt — Pause an Agent

Interrupts a running agent, stopping its execution immediately. The agent's state is preserved — it transitions to the Interrupted status and will not process any new invocations until resumed.

golem agent interrupt <AGENT_ID>

When to Use

• Temporarily pause an agent to prevent it from processing further invocations
• Stop a long-running or misbehaving agent without deleting it
• Perform maintenance — interrupt first, inspect state, then resume

Note: Interrupt only works on agents that are actively Running. Agents that are Idle or Suspended (e.g., waiting on a long sleep) cannot be interrupted — they are already paused. Sleeps longer than the configurable suspension threshold (10 seconds by default) cause Golem to suspend the agent automatically; only agents doing active work or shorter sleeps remain in Running state.

Examples

Interrupt a specific agent instance:

golem agent interrupt CounterAgent("my-counter")

Interrupt an agent in a specific environment:

golem agent interrupt my-env/CounterAgent("my-counter")

agent resume — Resume an Interrupted Agent

Resumes an agent that was previously interrupted. The agent transitions back to its normal state and will continue processing invocations, including any that were queued while it was interrupted.

golem agent resume <AGENT_ID>

Examples

Resume a specific agent instance:

golem agent resume CounterAgent("my-counter")

Resume an agent in a specific environment:

golem agent resume my-env/CounterAgent("my-counter")

Typical Workflow

1. Interrupt the agent to pause execution:

``shell golem agent interrupt CounterAgent("my-counter") ``

1. Verify the agent is interrupted (status shows Interrupted):

``shell golem agent get CounterAgent("my-counter") ``

1. Resume the agent when ready:

``shell golem agent resume CounterAgent("my-counter") ``

1. Verify the agent is running again:

``shell golem agent get CounterAgent("my-counter") ``