seeed-projects/seeed-jetson-developtool/imx477-a603-setup

IMX477 Camera Driver — A603 Carrier Board

The A603 carrier board requires a custom BSP that bundles the IMX477 driver. The correct package depends on your JetPack version. The device must be reflashed after download — there is no in-place driver install path.

Reference: references/source.body.md (Seeed wiki source, BSP download links)

Execution model

Run one phase at a time. After each phase:

• If output contains [STOP] → stop immediately, consult the failure decision tree
• If output ends with [OK] → tell the user "Phase N complete" and proceed to the next phase

Phase 1 — preflight: check JetPack version (~10 s)

Identify the installed JetPack/L4T version to select the correct BSP package.

cat /etc/nv_tegra_release

Expected output contains a line like:

# R35 (release), REVISION: 4.1   → JetPack 5.1.2
# R36 (release), REVISION: 3.0   → JetPack 6.0
# R36 (release), REVISION: 4.0   → JetPack 6.2

Map the result to a BSP variant:

Tell the user which BSP they need before proceeding. [OK]

Phase 2 — download BSP (~varies by connection)

Download the correct BSP package from the Seeed wiki. Exact download URLs are in references/source.body.md under the matching JetPack section.

After download, verify the archive is intact:

tar -tzf <BSP_PACKAGE>.tar.gz | head -5

If the listing shows files without errors → [OK] If tar reports an error → [STOP] archive corrupt

Phase 3 — flash device (~15–30 min)

This step erases the device. Confirm the user has backed up any data.

Put the device into recovery mode:

1. Power off the reComputer
2. Hold the REC button, then connect USB-C to the host PC
3. Release REC after 2 seconds
4. Confirm the device is visible on the host:

lsusb | grep -i nvidia

Expected: Bus ... NVIDIA Corp. APX

Extract and run the flash script:

tar -xzvf <BSP_PACKAGE>.tar.gz
cd <extracted_folder>
sudo ./flash.sh

The flash script will take 15–30 minutes. The device reboots automatically when done. [OK] when the device boots to the desktop.

Phase 4 — verify camera (~30 s)

After the device boots, test the IMX477 camera:

nvgstcapture-1.0 --sensor-id=0

A preview window should open. Press q to quit.

# Alternative: check device node exists
ls /dev/video*

[OK] if preview opens or /dev/video0 is present.

Failure decision tree